逆变器
所属分类：单片机开发
开发工具：C/C++
文件大小：18391KB
下载次数：13
上传日期：2019-07-07 19:58:54
上 传 者：
Xronde
说明： STM43F4核心板
实现用ir2104驱动的全桥整流电路的驱动，包括PWM以及频率测量，电流电压的闭环控制
(STM43F4 Core Board The drive of full bridge rectifier circuit driven by IR2104 is realized, including PWM, frequency measurement and closed-loop control of current and voltage.)
文件列表:
CORE (0, 2019-06-30)
CORE\cmsis_armcc.h (24423, 2015-10-30)
CORE\core_cm3.h (103909, 2015-10-30)
CORE\core_cmFunc.h (3620, 2015-10-30)
CORE\core_cmInstr.h (3636, 2015-10-30)
CORE\core_cmSimd.h (3662, 2015-10-30)
CORE\startup_stm32f103xe.s (16358, 2016-04-25)
HALLIB (0, 2019-06-30)
HALLIB\STM32F1xx_HAL_Driver (0, 2019-06-30)
HALLIB\STM32F1xx_HAL_Driver\Inc (0, 2019-06-30)
HALLIB\STM32F1xx_HAL_Driver\Inc\Legacy (0, 2019-06-30)
HALLIB\STM32F1xx_HAL_Driver\Inc\Legacy\stm32_hal_legacy.h (176630, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal.h (11612, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_adc.h (52075, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_adc_ex.h (48934, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_can.h (38445, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_can_ex.h (6955, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_cec.h (16212, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_conf_template.h (14651, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_cortex.h (19962, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_crc.h (6154, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_dac.h (10771, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_dac_ex.h (20847, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_def.h (8482, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_dma.h (19528, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_dma_ex.h (12120, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_eth.h (105935, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_flash.h (10768, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_flash_ex.h (39240, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_gpio.h (13269, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_gpio_ex.h (35974, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_hcd.h (9625, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_i2c.h (26132, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_i2s.h (19257, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_irda.h (25444, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_iwdg.h (9900, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_nand.h (11129, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_nor.h (10392, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_pccard.h (10705, 2016-04-25)
HALLIB\STM32F1xx_HAL_Driver\Inc\stm32f1xx_hal_pcd.h (35859, 2016-04-25)
... ...
实验器材:
MiniSTM32F103开发板V3版本
实验目的:
学习STM32待机唤醒功能的使用
硬件资源:
1,DS0(连接在PA8)
2,串口1(波特率:9600,PA9/PA10连接在板载USB转串口芯片CH340上面)
3,ALIENTEK 2.8/3.5/4.3/7寸TFTLCD模块(通过GPIO驱动,连接关系见lcd.h)
4,KEY_UP按键(即WK_UP按键,连接在PA0)
实验现象:
本实验通过长按（3秒）KEY_UP(WK_UP)按键开机，并且通过DS0的闪烁指示程序已经开始运行，再次长
按该键，则进入待机模式，DS0关闭，程序停止运行。类似于手机的开关机。
注意事项:
1,4.3寸和7寸屏需要比较大电流,USB供电可能不足,请用外部电源供电(5V电源，接VOUT2即可).
2,本例程在LCD_Init函数里面(在ILI93xx.c),用到了printf,如果不初始化串口1,将导致液晶无法显示!!
3,LCD模块在开发板的LCD接口上面，必须靠右插
4,默认是待机状态,所以上电后必须长按KEY_UP(WK_UP)按键以开机.
5,不要把1820和PA0的跳线帽跳上,否则可能导致按键"不灵".
正点原子@ALIENTEK
2014-3-08
广州市星翼电子科技有限公司
电话：020-38271790
传真：020-36773971
购买：http://shop62103354.taobao.com
http://shop62057469.taobao.com
公司网站：www.alientek.com
技术论坛：www.openedv.com
近期下载者：
相关文件：
收藏者：