stab
所属分类：单片机开发
开发工具：C/C++
文件大小：1289KB
下载次数：5
上传日期：2020-05-21 12:12:44
上 传 者：
Pratiek
说明： I have uploded stebilizer source code and curcuit microchip 16f676
文件列表:
stab\16f676.pdf (1376666, 2018-07-19)
stab\16f676_g.lkr (2794, 2008-03-20)
stab\1ph_dig_stab_wiring_diagram.PNG (39511, 2019-10-30)
stab\funclist (199, 2019-11-14)
stab\P16F676.INC (9421, 2009-03-06)
stab\stab.as (42462, 2019-11-14)
stab\stab.c (6405, 2019-11-14)
stab\stab.cof (28579, 2019-11-14)
stab\stab.dep (321, 2019-11-14)
stab\stab.hex (4817, 2019-11-14)
stab\stab.hxl (2689, 2019-11-14)
stab\stab.lst (117380, 2019-11-14)
stab\stab.map (11974, 2019-11-14)
stab\stab.mcp (1034, 2019-11-14)
stab\stab.mcs (6753, 2019-11-14)
stab\stab.mcw (82432, 2019-11-14)
stab\stab.obj (16316, 2019-11-14)
stab\stab.p1 (49651, 2019-11-14)
stab\stab.pre (14188, 2019-11-14)
stab\stab.rlf (169834, 2019-11-14)
stab\stab.sdb (16825, 2019-11-14)
stab\stab.sym (6150, 2019-11-14)
stab\startup.as (1996, 2019-11-14)
stab\startup.lst (4916, 2019-11-14)
stab\startup.obj (1509, 2019-11-14)
stab\startup.rlf (5478, 2019-11-14)
stab (0, 2019-11-14)
WoRkING detis FOR MICROCONTROLLER BASED DIGITAL STABLIZER KITS
1 PHASE, 90 290 VAC 5 step
WIRING: Only one L.T. is required. Please do wiring as per above diagram.
SETTING: When you connect 95V input from variac the output should be 200V. Now increase
input and check output.When output reaches between 244/245V R3 goes ON and output will reach
near about to 205V. Run/check all steps.When you connect 290V input from variac the output should
be 240V.move preset 202(2k) till RL4 off.
LOW CUT SETTING: Low cut shall be work on connecting Jumper J2
INDICATIONS: If time delay mode is presented the LED blinks sholly at the time of power
on.If I\P voltage is out of range (high voltage) LED blinks fastly & /buzzer starts beeping also
fastly. If I\P low voltage range LED LED blinks slowly & buzzer starts beeping also slowly.
近期下载者：
相关文件：
收藏者：