XT30-2plus2-connector-pcb
所属分类:硬件设计
开发工具:Others
文件大小:0KB
下载次数:0
上传日期:2023-12-31 16:49:44
上 传 者:
sh-1993
说明: PCB,用于防止小连接器在连接时发生故障
(a PCB designed to keep small connectors from failing when attached)
文件列表:
XT302+2 PCB mod/
LICENSE
# XT30-2plus2-connector-pcb
a PCB designed to keep small connectors from failing when attached
**Please note that the board is not finished and will change in following versions**
i made this PCB because i don't want to make makeshifts anymore
# Features
- holds small (data) connectors of male side of XT30 2+2 so it cannot be slipped of connecting thus breaking the connector
- Holds 16AWG max. cables on main connectors and 24AWG max. on small (data) connectors
- 3 boards per panel idk but this hopes to not make PCB makers mad
# Usage
### 3D printers: swappable hotends (thermistor connects to small (data) connectors and the heater core connects to main connector)
### idk what extra usage are but data or sensing goes to small (data) connectors and powered load goes to main connector.
# BOMs
## Board (excluding cables and solder)
- 1X male side of XT30 2+2
## Load (excluding cables and solder)
- 1X female side of XT30 2+2
# Assembly procedure
**Avoid pre-tinning the cable and PCB until the cable has fit through the board, unless you know what you're doing, otherwise you'll have a hard time solding the cable to the PCB.**
- fit cables to the PCB, make sure the cable going to the PCB is the one it connects, then solder cables to the board
- put the connector to the PCB, make sure it fits
- solder the connectors of XT30 2+2 and the PCB, Avoid heating it for too much as it will melt the connector and get the cable disconnected
近期下载者:
相关文件:
收藏者: