文件列表:

opengk\.cvsignore (85, 2001-10-29)
opengk\custom.cxx (3174, 2002-10-24)
opengk\custom.h (436, 2001-08-03)
opengk\CVS (0, 2002-12-12)
opengk\CVS\Entries (771, 2002-12-12)
opengk\CVS\Repository (16, 2002-12-12)
opengk\CVS\Root (50, 2002-12-12)
opengk\CVS\Tag (9, 2002-12-12)
opengk\main.cxx (25848, 2002-11-28)
opengk\main.h (3591, 2002-10-21)
opengk\Makefile (1039, 2001-08-03)
opengk\messages.mc (364, 2001-08-03)
opengk\mpl-1.0.htm (20583, 2001-08-17)
opengk\opengk.dsp (8393, 2002-10-09)
opengk\opengk.dsw (535, 2001-08-07)
opengk\opengk.gif (3812, 2001-10-09)
opengk\opengk.ico (2998, 2001-08-03)
opengk\precompile.cxx (376, 2001-08-03)
opengk\version.h (1331, 2002-12-12)

Open GK ------- 1. Introduction This is a very basic H.323 Gatekeeper. It does not do a lot yet. You can register with it 2. Command line options Linux To run as a normal executable for a quick test use "opengk -xc". To run as a daemon in the background use "opengk -dl /var/log" There are other options for where log files go etc, and these may be shown by simply going "opengk". Windows ***/ME To run as a normal executable for a quick test use "opengk debug". To run in the background just run "opengk". To configure so it runs in the background on reboot go "opengk install". Windows NT/2000/XP To run as a normal executable for a quick test use "opengk debug". You may dp this as any user. To run in the background run "opengk install" and "opengk start". You must be an Administrator to do this. Note that this will permanently configure the operating system so it runs in the background on every reboot. Use "opengk remove" to stop the service from running in the background. 4. Configuration & Status There is a configuration file but the user would not normally edit it. All configuration is done through a HTTP interface using a normal browser. Simple go to http://hostname:1719 where hostname is the ip address or hostname of the machine running the gatekeeper. When you try and use the Parameter or Status page a username and password may be required. BY default the authentication feature is disabled until you select a username and password. However, older versions used a default value of "admin" and "secret" respectively. If you have forgotten the password then it cannot be retrieved. You will have to either use "opengk deinstall" to completely deinstall the system wiping all of the configuration you may have. Or go into a Registry Editor and remove the "Username" and "Password" field from the section: HKEY_LOCAL_MACHINE SOFTWARE Equivalence Pty. Ltd. OpenH323 Gatekeeper CurrentVersion Parameters 5. Support Don't expect too much! Ask questions in the OpenH323 mailing list and hopefully someone will answer you! Go to http://www.openh323.org for more information on the mailing list. Equivalence Pty Ltd.

近期下载者：

相关文件：

评论：[我要评论] [举报此文件]

收藏者：