HexNanoMWC_QUAD-master
所属分类：多媒体编程
开发工具：Objective-C
文件大小：151KB
下载次数：10
上传日期：2014-12-19 07:23:53
上 传 者：
宋老板
说明： MWC飞控代码，audio编程。学习研究MWC飞控源码，自行DIY飞控。
(MWC code,audio program.)
文件列表:
Alarms.ino (23521, 2014-08-20)
CREDITS.txt (6687, 2014-08-20)
EEPROM.ino (7207, 2014-08-20)
GPS.ino (51145, 2014-08-20)
HexNanoMWC_QUAD.ino (47095, 2014-08-20)
IMU.ino (11856, 2014-08-20)
LCD.ino (91986, 2014-08-20)
Output.ino (54527, 2014-08-20)
RX.ino (32461, 2014-08-20)
Sensors.ino (64347, 2014-08-20)
Serial.ino (34310, 2014-08-20)
config.h (64852, 2014-08-20)
def.h (75568, 2014-08-20)
def.h.bak (75565, 2014-08-20)
tinygps.h (1200, 2014-08-20)
HexNanoMWC_QUAD
===============
A modified MWC2.2 flight control for FlexBot quad board.
And the project is one part of the [FlexBot Project](http://http://flexbot.cc/wiki/).
##Source Code
You can either download the source using the "Download ZIP" button at the bottom left of the github page, or you can make a clone using git:
```
git clone https://github.com/HexAirbot/HexNanoMWC_QUAD.git
```
####Latest release
[version 1.0.3 source code](https://github.com/HexAirbot/HexNanoMWC_QUAD/archive/v1.0.3.zip)
####How to compile
1.Download the Arduino IDE (you should use the version 1.0.5+)
2.Download the source code here, and put all the source files (.ino file) under folder HexNanoMWC_QUAD.
3.Open the main file HexNanoMWC_QUAD.ino with the Arduino IDE, and the IDE will also automatically open other source files.
4.Connect your Flexbot via USB
5.Set the Board in your IDE to Arduino Leonardo
Select the correct COM Port
6.Click the verify and then the upload button
##Development
The FlexBot Project is open source.
To contribute, you can send a pull request on Github, or share your idea to the [forum](http://makedesignshare.com).
##Support
[Website](http://flexbot.cc)
[Wiki](http://flexbot.cc/wiki)
[Forum](http://makedesignshare.com)
近期下载者：
相关文件：
收藏者：