PMWHEX-V1.3
所属分类：单片机开发
开发工具：Visual Basic
文件大小：7276KB
下载次数：1419
上传日期：2007-07-30 18:55:03
上 传 者：
yueliang150
说明： 三菱梯形图转成51单片机HEX文件。
三菱软件写好梯形图，再运行转换软件，设定好51单片机的输入输出，
打开写好的梯形图，转换出的就是hex文件，烧录到51单片机，51单片机
就可以执行PLC的动作了。51单片机控制板价格便宜，可以代替简单场
合的PLC，控制成本降低。
1：把PWM转换后，在PWM文件下生成一个HEX文件。
2：生成的文件很大，51单片机要选用8K以上(AT89S52就是8K)储存量的。
3：把HEX文件下载到单片机就可以用了。
(Mitsubishi ladder into 51 single-chip HEX file. Mitsubishi software written ladder, and then run the conversion software, set 51 single-chip input and output, open ladder-written, conversion is a hex file, burn to 51 single-chip, 51 single-chip microcomputer can be implementation of the action of PLC. 51 Single-chip panel prices, can replace the simple occasions PLC, control and lower the cost. 1: after the PWM converter, PWM documents generated in a HEX file. 2: generate a lot of paper, 51 single-chip 8K to choose more than (AT89S52 is 8K) storage capacity. 3: The HEX file can be downloaded to a single-chip microcomputer used.)
文件列表:
PMWHEX-V1.3 (0, 2007-07-14)
PMWHEX-V1.3\asycfilt.dll (143632, 2003-07-17)
PMWHEX-V1.3\COMCAT.DLL (22288, 1998-05-31)
PMWHEX-V1.3\comdlg32.ocx (140288, 1999-05-07)
PMWHEX-V1.3\fx1n.hex (10547, 2007-06-23)
PMWHEX-V1.3\io.dat (168, 2007-06-23)
PMWHEX-V1.3\Keil (0, 2007-07-14)
PMWHEX-V1.3\Keil\C51 (0, 2007-07-14)
PMWHEX-V1.3\Keil\C51\ASM (0, 2007-07-14)
PMWHEX-V1.3\Keil\C51\ASM\89c51ix2.inc (3097, 2003-03-04)
PMWHEX-V1.3\Keil\C51\ASM\AT898252.INC (3281, 1997-12-15)
PMWHEX-V1.3\Keil\C51\ASM\at89c5114.inc (3551, 2002-10-07)
PMWHEX-V1.3\Keil\C51\ASM\AT89S53.INC (5812, 1997-12-15)
PMWHEX-V1.3\Keil\C51\ASM\AT8xc5103.inc (2403, 2001-11-16)
PMWHEX-V1.3\Keil\C51\ASM\C8051F000.INC (9599, 2001-05-08)
PMWHEX-V1.3\Keil\C51\ASM\C8051F200.INC (6671, 2001-05-08)
PMWHEX-V1.3\Keil\C51\ASM\REG152.INC (3363, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG320.INC (3317, 1998-01-16)
PMWHEX-V1.3\Keil\C51\ASM\REG410.INC (2513, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG451.INC (2025, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG452.INC (2851, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG453.INC (1955, 1997-12-09)
PMWHEX-V1.3\Keil\C51\ASM\REG504.INC (3072, 1997-11-26)
PMWHEX-V1.3\Keil\C51\ASM\REG505C.INC (3037, 1997-11-21)
PMWHEX-V1.3\Keil\C51\ASM\REG505L.INC (2668, 1997-11-26)
PMWHEX-V1.3\Keil\C51\ASM\REG509.INC (4684, 1997-12-08)
PMWHEX-V1.3\Keil\C51\ASM\REG51.INC (1705, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG515.INC (2813, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG515A.INC (2833, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG515C.INC (3216, 1997-12-09)
PMWHEX-V1.3\Keil\C51\ASM\REG517.INC (3532, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG517A.INC (3752, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG51F.INC (3031, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG51G.INC (2115, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG51GB.INC (3871, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG52.INC (2148, 1996-09-13)
PMWHEX-V1.3\Keil\C51\ASM\REG520.INC (3362, 1997-07-15)
PMWHEX-V1.3\Keil\C51\ASM\REG528.INC (2511, 1997-11-20)
PMWHEX-V1.3\Keil\C51\ASM\REG530.INC (4006, 2000-02-07)
PMWHEX-V1.3\Keil\C51\ASM\REG552.INC (4156, 1996-09-13)
... ...
MONITOR-51 Version 2.9 Release Note:
====================================
Since version 2.8 the MONITOR 51 can be installed on DALLAS 80C320/520/530
target systems. Previous versions were not able to handle multiple DPTR
register and crashed when a different DPTR was selected.
Please use serial type 4, 5, 11 or 12 during installation when a DALLAS
microcontroller should be used.
Since version 2.9 the MONITOR 51 can execute some code before and after
a go and procedure step command. This might be used for changing the memory
layout or changing the serial transmission parameters.
In order to do this, you can insert some code after the BEFORE_GO and AFTER_GO
labels in the INSTALL.A51 configuration file.
近期下载者：
相关文件：
收藏者：