文件列表:

comm test\BasicComm.exe (49152, 2000-04-05)
comm test\BasicComm.PDM (3494, 2000-04-05)
comm test\BasicComm.TXT (319, 2000-04-05)
comm test\BasicComm.vbp (1027, 2000-04-05)
comm test\BasicComm.vbw (52, 2008-05-20)
comm test\frmMain.frm (26157, 2000-04-03)
comm test\MSSCCPRJ.SCC (194, 2008-05-20)
comm test\Package (0, 2008-05-19)
comm test (0, 2008-05-20)

Basic Communications Program Malcom Kemp April 3, 2000 This program was written to facilitate the development of a communications program for the PIC microcontroller. The overriding criteria were to be able to deliver precise 8-bit values to the PIC over the RS-232 Tx line, and to receive and display precise 8-bit values from the PIC over the Rx line. This program was developed from a program that Adam Davis made available through the PICLIST (PIC microcontroller discussion list). The USART on the PC can be explicitly controlled through the “Settings” menu selection. When any of the Port, Speed, Data Bits, Parity, or Stop Bits selections are changed, the port is disconnected, the change made, and then the port is reconnected, if it was open to start. There is a small chance that data may be lost in this transition. It is expected that the port will be set to the proper operating parameters before the port is connected. The “View” menu selection will set the display of the output string and the response string to either an escaped ASCII, or to a hex display. The hex display is a two character hex representation of each byte separated by a space. The ASCII display displays printable characters, but will escape non-printable characters with a “\” character as follows: \b backspace, hex byte 0x08 \t tab, hex byte 0x09 \n new line (line feed), hex byte 0x0A \r return, hex byte 0x0D \xHH any unprintable hex character 0xHH \\ backslash character \ The output string can be edited at any time, just follow the rules of the display. For the hex display, the hex characters must be space delimited. The field will be read, edited and rewritten when you leave the field. Be sure what is written back is what you intended. The “send” button will transmit the output string out the RS-232 transmit of the selected port. The “clear” buttons can be used to clear the contents of the output string or the response string at any time. Although there is a limited space for display of the output string and the response string, they can actually be very long. The cursor is left at the right end of the string, but you can use the “home”, “end” and arrow keys to view portions of the string that may be hidden.

近期下载者：

相关文件：

评论：[我要评论] [举报此文件]

收藏者：