RSencoder
所属分类:通讯编程
开发工具:VHDL
文件大小:5KB
下载次数:38
上传日期:2008-07-18 08:49:57
上 传 者:
eroc
说明: 关于rs码编码器的相关程序,利用硬件语言实现
(Rs encoder code on the relevant procedures, take advantage of the hardware language)
文件列表:
RS encoder\RS encoder\reed_solomon.v (6783, 2007-05-27)
RS encoder\RS encoder\rs_testbench.v (6247, 2007-05-27)
RS encoder\RS encoder (0, 2007-05-27)
RS encoder (0, 2008-03-03)
I/O inputs -
Inputs :
datain (8 bits) = serial input where message data is fed. If the message polynomial of form,
d_nX^n + d_(n-1)X^(n-1) + ......etc., then d_n followed by d_(n-1) in the next
clock cyle, .....etc. datain should contain a new message byte at every clock cycle
as long as the valid is high.
gin0.....gin15 (8 bits each ) = Generator polynomial co-effcients. The generator polynomial
is form X^16+gin15X^15+gin14X^14+ ......gin1X+gin0.
valid = Pull high when data becomes available. Pull low when all message bytes (total of 239
bytes) has been entered. By pulling valid low the contents of the registers are freezed.
Pull high when the next block (239 bytes) of message data is available.
clkin = input clock.
rst = reset signal to initialize registers (to all zeros).
Outputs :
q0....q15 (8 bits each) : Parity bytes in the polynomial form,
q15X^15+q14X^14+ ......q0. Latch externally if required. Valid as long
as valid signal is low.
近期下载者:
相关文件:
收藏者: