MSP430FR57xx_01.zip - MSP430FR57x Demo - Toggle P1.0 using software
Description: Toggle P1.0 using software.
ACLK = n/a, MCLK = SMCLK = TACLK = default DCO = ~625 KHz,2011-10-07 15:03:56,下载6次
MSP430FR57xx_uscib0_i2c_05.zip - MSP430FR57xx Demo - USCI_B0 I2C Slave TX single bytes to MSP430 Master
Description: This demo connects two MSP430 s via the I2C bus. The master
reads from the slave. This is the SLAVE code. The TX data begins at 0
and is incremented each time it is sent. A stop condition
is used as a trigger to increment the outgoing data.
The USCI_B0 TX interrupt is used to know
when to TX.,2011-10-07 15:02:26,下载9次
MSP430FR57xx_uscib0_i2c_04.zip - MSP430FR57xx Demo - USCI_B0 I2C Master RX single bytes from MSP430 Slave
Description: This demo connects two MSP430 s via the I2C bus. The master
reads from the slave. This is the MASTER CODE. The data from the slave
transmitter begins at 0 and increments with each transfer.
The USCI_B0 RX interrupt is used to know when new data has been received.,2011-10-07 15:01:32,下载15次
MSP430FR57xx_uscia0_spi_10.zip - Description: SPI slave talks to SPI master using 3-wire mode. Data received
from master is echoed back.
ACLK = 32.768kHz, MCLK = SMCLK = DCO ~ 1MHz
Note: Ensure slave is powered up before master to prevent delays due to
slave init.,2011-10-07 15:00:33,下载4次
MSP430FR57xx_uscia0_spi_09.zip - Description: SPI master talks to SPI slave using 3-wire mode. Incrementing
data is sent by the master starting at 0x01. Received data is expected to
be same as the previous transmission TXData = RXData-1.
USCI RX ISR is used to handle communication with the CPU, normally in LPM0.
,2011-10-07 14:57:05,下载7次
MSP430FR57xx_ta0_01.zip - Module: TimerA0
MSP430FR57xx_ta0_01.c
Timer0_A3, Toggle P1.0, CCR0 Cont Mode ISR, DCO SMCLK,2011-10-07 14:56:14,下载4次
MSP430FR57xx_adc10_01.zip - MSP430FR57xx_ADC10, Sample A1, AVcc Ref, Set P1.0 if A1 > 0.5*AVcc,2011-10-07 14:54:04,下载4次