FJYL57AIWE4II7C.zip - Software that is described herein is for illustrative purposes only
which provides customers with programming information regarding the
products. This software is supplied "AS IS" without any warranties.
NXP Semiconductors assumes no responsibility or liability for the
use of the software, conveys no license or title under any patent,2017-11-10 18:11:36,下载1次
lpcopen_2_10_keil_iar_ea_devkit_1788.zip - The CS signal selects one slave, and the slave takes over the MISO pin. If a slave is not selected, then it shall leave the MISO pin in hi-z state. If multiple slaves have their CS signal asserted, they will try to take control of the MISO pin and damage their MISO pins. For example, if one slave drives the signal high (connect to 3.3v) and the other drives it low (connect to ground), then short-circuit will occur damaging this pin.,2017-11-10 18:10:27,下载2次
Fujitsu.zip - After sending one byte over SPI, you have to clear one byte in the data register (DR) again. In SPI you always send and receive a byte You cannot just send OR receive a byte, it's always AND. The technical explanation is that there is only one clock line, and two data lines (MISO and MOSI),2017-11-10 18:09:07,下载1次
CG-Edit.zip - I have an LPCXpresso54608 board "Rev A" but the only schematics available are for the Rev C & B boards. The documents all refer to jumpers that are not on my board, any chance of the documents for rev A too. Thanks!,2017-11-10 18:06:19,下载1次
arktur04-lcd-demo-ce2cc8e15ea9.zip - I am trying to verify the ADC speed with the LPCXpresso54608 eval board. I stated with the lpc_adc_dma example and then modified the dma to have a linked list of 100 descriptors which then places the ADC data,2017-11-10 18:05:38,下载3次