fet140_uart01_0115k.rar - // Description: Echo a received character, RX ISR used. Normal mode is LPM0,
// USART0 RX interrupt triggers TX Echo.
// ACLK = MCLK = UCLK0 = LFXT1 = 8MHz
// Baud rate divider with 8Mhz XTAL = 8000000/115200 = 0069 (0045h)
// //* An external 8Mhz XTAL on XIN XOUT is required for ACLK *//
// //* Min Vcc required varies with MCLK frequency - refer to datasheet *// ,2011-12-23 00:28:07,下载3次
fet140_ta_03.rar - Description: Toggle P1.0 using software and Timer_A overflow ISR.
// In this example an ISR triggers when TA overflows. Inside the TA
// overflow ISR P1.0 is toggled. Toggle rate is approximatlely 12Hz.
// Proper use of the TAIV interrupt vector generator is demonstrated.
// ACLK = n/a, MCLK = SMCLK = TACLK = default DCO ~800kHz,2011-12-23 00:25:02,下载3次
fet140_spi0_07.rar - Description: SPI Master communicates at fast as possible, full-duplex with
// SPI Slave using 3-wire mode. The level on P1.4/5 is TX ed and RX ed to P1.0
// and P1.1. Master will pulse slave Reset on init to insure synch start.
// Master normal mode is LPM0.,2011-12-23 00:22:06,下载4次
fet140_i2c_01.rar - 演示了如何操作MSP430F149的i2c功能,2011-12-23 00:20:46,下载4次
fet140_dma_01.rar - 演示了如何操作MSP430F149单片机的DMA操作,2011-12-23 00:19:32,下载11次
fet140_adc12_01.rar - 展示了msp430f14x单片机的AD操作,2011-12-23 00:17:52,下载4次
TIMER_32BITS.rar - 定时器被设置为每秒产生两次中断，每个中断都
翻转一次相应的GPIO口，同时LED指示灯指示每次中断,2010-10-10 22:52:51,下载6次
TIMER_16_PWM.rar - 将定时器设置为16位PWM模式下的相应配置,2010-10-10 22:52:07,下载6次
TIMER_16_CAP_COUNT.rar - 使用KEY1输入边沿触发，用定时器递减计数，当计数值和匹配值相等时
，进入中断：LED3的状态翻转，每按KEY1键四次，LED的状态改变一次,2010-10-10 22:50:30,下载6次
PLL_SET.rar - 设置直接使用外部晶振与使用PLL,10分频的源代码,2010-10-10 22:49:44,下载8次
GPIO_INT.rar - 程序正常运行时，熄灭LED指示灯
当按键按下时·触发中断，点亮LED指示灯。按键放开后
又熄灭LED指示灯,2010-10-10 22:48:04,下载7次