Analog to Digital Converter Example Program =========================================== Project: ADC Converter Author: Kevin Bernhardt This example program shows how to configure and use the A/D Converter of the following microcontrollers: * Silicon Laboratories, Inc. C8051F320 * Silicon Laboratories, Inc. C8051F321 After configuring the A/D Converter, the program reads A/D channel 0 and outputs the converted value using the serial port. To run this program... 1. Select the device from the pull-down target list 2. Build the project (Project - Build Target) 3. Start the uVision Debugger 4. Open the Serial Window (View - Serial Window 1) 5. Open the Toolbox (View - Toolbox) 6. Click Go or Run (F5) 7. Click on the Toolbox buttons to change input voltages A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change. Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. �Vision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals graphically.